cutting diagram for oval wedding cake tiers

Oval Wedding Cake Tiers:

1. From the fuller outer edge of the oval, measure in 2 inches and make a horizontal cut all the way from left to right.

2. Slice 1 inch pieces from this row. (NOTE: As you approach the curved “ends” of the oval you will leave more than 1 inch, so each piece is approximately still 2 inches x 1 inch)

3. Move in 2 inches from the cut edge and cut again horizontally from left to right.

4. Repeat steps 2 and 3 until the entire tier is cut.

♥ Remember: To make the cuts, dip a large, sharp knife in hot water. Shake off the excess water and apply steady, even pressure to the knife handle to make a clean slice (not too fast and not too slow) into the cake. Wipe the knife with a towel between each cut to clean off frosting left behind from the last one. Carefully drop each piece of cake on its side on a dessert plate and place on a tray, serving table, or wheeled cart to facilitate serving large amounts at once.

Rose Haller, Wedding Specialist
Exclusively for WeddingLDS.info
Copyright © 2010 WeddingLDS.info. All rights reserved.

Leave a Reply

Your email address will not be published. Required fields are marked *

Comment *






Copyright © 2010-2015 WeddingLDS.info. All rights reserved.

WeddingLDS.info strives to be consistent with the teachings of The Church of Jesus Christ of Latter-Day Saints. This website is not an official site of the LDS Church. Some of the links may take you to sites not maintained by us. WeddingLDS.info claims no authorship, nor any responsibility for the information contained on those sites.

Contact

Privacy Policy/Terms of Service